Ring Pillow & Flower Basket

Since I couldn’t find a pillow and basket in my wedding colors at a low price, I decided to make my own. This was my first craft for our wedding, and it obviously lead to many more! It’s very easy, and I hope this is easy enough to follow.

You will need:

– Tacky glue

– Ribbon in your wedding colors

– Small rhinestones (optional)

– Small sewing kit

– A plain ring pillow and flower girl basket

 

I got my ring bearer pillow at Walmart for about $11. The tacky glue, ribbon, and rhinestones I got at Michael’s. (I apologize for some of the photos. They were taken with my phone and aren’t that great!)

My plain ring pillow from Walmart.

Wrap your chosen ribbons around the pillow to get a measurement and cut accordingly. I used a wide sheer purple and a narrower solid blue to layer. Trim the edges of the wide ribbon so it looks like it disappears behind the main bow (if your pillow doesn’t have a bow or anything on the front, you can make a bow using either white ribbon or one of your wedding colors and tack or sew it to the front. Here is a great bow tying tutorial). Because one of my ribbons was sheer, I stitched them to the pillow under one of the bow ears, with the solid ribbon under the sheer.

Stitch or glue one end under the bow, making sure the ribbon is lying over top and centered on whatever preexisting ribbon is there (if your pillow has one). Flip your pillow over and pull the ribbon flush so it lays tight and flat against it. Stitch it where the existing ribbon is stitched to create the handle, then stitch it again in the same place on the other side. Wrap it back around to the front and stitch the end under the opposite side of the front bow. Then do the same steps with your next ribbon (if you have one), laying it centered and flush just like the first one. If this ribbon is wider and sheer like mine, don’t make it part of the handle. Instead, cut it and stitch or glue it where the handle starts and do the same on the other side. The underside should look like this:

The backside of the pillow, showing the handle or hand slot for the ring bearer.

The front should look something like this:

The pillows front side, almost finished.

I used a thin purple ribbon to add to the tying ribbons that hang off the front. I cut them to the same length and stitched them up underneath the heart embellishment. I also decided to monogram the pillow with rhinestones. Put some tacky glue on a paper plate and use tweezers to carefully pick up each rhinestone, dip the back of it in the glue, and position it on the pillow. Create any design or monogram you’d like! I’d suggest practicing on a flat surface first though 😉 Tacky glue goes on white but dries clear, so if it comes out around the edges you won’t see it when it dries.

 

The flower girl basket I bought at Michael’s, for somewhere around $12.

The before image of the flower basket.

I did the same ribbon overlay here as I did for the pillow. Blue first, then purple. I used tacky glue rather than stitching. Glue one end to the middle of the bottom of the basket and let dry. Then pull tight and flush and glue the remaining end to the inside of the basket. (I glued mine close to the bottom on the inside, so when it was full of petals you could see the ribbon on the sides.) Do the same on the other side, and then repeat with the sheer ribbon, or whatever other ribbon you’ve chosen. I tied bows around the four ends of the handles to add a girly touch for my nieces.

Here are the finished products. Inexpensive, easy to make, and made to match our wedding perfectly.

The finished basket and pillow.

Advertisements